Enrico Pesatori snc - EPK 300 DIELECTRIC STRENGHT TEST APPLIANCE

DIELECTRIC STRENGHT TEST APPLIANCE

Maximum use versatility.
Suitable for automatic lines and single tests
Four operating modes
Fit for tests according to CEI 42, IEC 1180 and EN 61180 standards.
Digital equipment
Remote controllable

CHARACTERISTICS

This dielectric strength test appliance was conceived for making high voltage tests up to 100 KV in laboratories, on automatic lines and for single piece tests, according to national and international standards.
Application fields are various: domestic appliances, components industry, transformers, engines, office machinery, electromedical and generic equipment.

TEST MODES

EPK 300 dielectric strength test appliance can be used in four different test modes.

1^stTEST
It is performed for a pre-defined time which starts when voltage increase takes place.

Timer starting time

2^ndTEST
It is performed for a pre-defined time which starts when voltage goes to pre-set level.

Timer starting time

3^rdTEST
It starts by switching the START button and ends by switching the STOP button.

4^thTEST
DESTROY: This test is done to locate where the fault takes place. The intervention is deactivated so that voltage can burn and show the fault. After the test, both with positive or negative result, high voltage cut happens whenever network voltage reaches Ø level, thus avoiding dangerous overvoltage which could damage the tested object. If the tests shows negative result, or if the pre-set current threshold is exceeded, high voltage supply stops. The value of the voltage which caused the fault is stored on the voltmeter until setting is completed, while a beep announces the end of the test. The values of pre-set voltage and current used for the test are chosen through multiturn potentiometers, by reading absolute values on the instruments placed on the appliance front board.

TECHNICAL CHARACTERISTICS

SUPPLY	230 Vac 50 ~ Hz
OUTPUT VOLTAGE	*from 400 V to 5 KV AC ()**
H. V. TRANSFORMER POWER	500 VA
INTERVENTION CURRENT	Adjustable from 2 to 100 mA
INCREASE SPEED	500 V/sec or on demand
PRECISION OF REGULATION	± 50 V on 5 KV AC
TIMER	from 1 to 99 sec
PRECISION OF READING	According to CEI 42
DISPLAY	LCD 3 ½ digit
VOLT RESOLUTION	10 V
AMP. RESOLUTION	0,1 mA
INPUTS/OUTPUTS	Button remote control, safety locking, test end
SIZE	Rack 19" h 4U, depth 420 mm (L=530 W=225 D=420)
PESO	30 Kg. about *() PROVIDED ON DEMAND OTHER VALUES UP TO 100 KV**

(Because of technical evolution, characteristics may vary without notice)

Back to previous page